|
|
|
Kto jest w sklepie?
Sklep przegląda 5705 gości i
2 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
HKTS5/HKTS6
SUB-TS5/TS6 Amplifier
LINE VOLTAGE US 120vac/60Hz Parameter Amp Section Type (Class AB, D, other) Load Impedance (speaker) Rated Output Power THD@ Rated Power THD @ 1 Watt DC Offset Damping factor Input Sensitivity Input Frequency SUB Input Signal to Noise SNR-A-Weighted SNR-unweighted SNR @ 1W-unweighted Residual Noise Floor Residual Noise Floor Yes/No Yes Specification
harman/kardon
100w Powered Subwoofer Amplifier
Notes Normal Operation Conditions Notes
Hi/Lo Line Unit 108-132 Vrms Unit QA Test Limits
AB AB 4 Ohms 100 Watts 0.08 % 0.1 % 10 mV-DC >100 DF
n/a n/a 95 0.3 0.5 20 50
Nominal 1 input driven 22k filter 22k filter @ Speaker Outputs
External Sink required for Class AB Z-curve required
Measured at speaker terminals, Output power 90 Watts THD 0.1 % Nominal Freq. To Rated Power 1 input driven SUB input driven only
50 Hz 135 mVrms 100 80 60 1.5 1 dBA dBr dBr mVrms
mVrms(max)
50 ±2dB 90 75 55 2.5 2
rel. to rated power A-Weighting filter rel. to rated power 22k filter rel. to 1W Output 22k filter Volume @max, using RMS reading DMM/VOM (or A/P) Volume @max, w/ A/P Swept Bandpass Measurement (Line freq.+ harmonics) Nominal
Input Impedance SUB Line input Filters Low Pass (fixed or variable) Slope & Q Subsonic filter (HPF) Slope & Q Limiter (yes/no) Features LFE Input Phase Switch (yes/no) Volume pot Taper (lin/log) ATO Input Configuration SUB Line level Signal Sensing (ATO) Auto-Turn-On (yes/no) ATO Input Frequency ATO Level ATO Turn-on time Auto Mute/ Turn-OFF Time Power on Delay time Transients/Pops ATO Transient Turn-on Transient Turn-off Transient Efficiency Stand-by Input Power
>15 K ohms fixed -dB/Octave Hz dB/Octave --
n/a ±2dB n/a ±2dB n/a n/a functional functional functional functional functional
YES YES NO log YES LFE YES 50 Hz 2 mV 5 ms
BW Limited to 500 Hz
---
Single RCA Input
--
functional functional functional functional functional functional 10 100 100 15 2mV@50Hz into Line Input w/ 1 ch. driven Amp connected and AC on, then input signal applied T before muting, after signal is removed Auto turn of time (T) must be 10 > T <15 AC Power Applied @ Speaker Outputs @ Speaker Outputs @ Speaker Outputs @ nom. line voltage
15 minutes 3 sec. 5 mV-peak 50 mV-peak 50 mV-peak 13 Watts
AC Line cycled from OFF to ON AC Line cycled from ON to OFF Maximum allowable input power under nominal Input voltage and frequency, HOT or COLD operation. 100 Watts @ 4 Ohms nominal line voltage
Power Cons.@rated power Protection Short Circuit Protection Thermal Protection DC Offset Protection Line Fuse Rating
185 Watts YES 65 deg. C ---
195 functional functional functional 2.5
@ nom. line voltage Direct short at output @1/8 max unclipped Power DC present at Speaker Out leads Type-T or Slo Blo
YES -2.5 Amps
Temperature rise should not exceed 35K rise Relay or crowbar (for driver/fire protection) External fuse with UL/SEMKO rated holder
2
|
|
|
> |
|
